| |
For Chimney made up of RCC – single flue / multi flue chimney, Structural steel chimney, Our insulation material creates an environment efficient and safe.
Typical Applications Chimney Supports Bottom of the chimney flue is mounted on the floor beam using load bearing insulations blocks having No. of load bearing dowel as shown above. As our product listed below has got good compressive strength with low thermal conductivity, it is best suited for such type of load bearing applications. It also prevents flow of heat from inside of the chimney flue towards floor beam.
Our insulation blocks are also used to cover chimney flue surfaces. Insulation Supports used as below in industrial Chimneys– - 50 thick load bearing insulation blocks/sheets-Syndaniyo preset on MS plates
- 75 thick load bearing insulation blocks/sheets- Syndaniyo preset on MS plates
- 25 dia 100 long dowels fabricated from load bearing insulation block materials- Syndaniyo
Description: Top plate formed of two numbers our insulation blocks each made of minimum 50mm thick regid, non-combustible asbestos fibre reinforced board (equivalent of Tenmat product= SINDANYO BLOCKS NATURAL GRADE CS-51 ) bonded to MS plate at top and bottom. |
| |
Our boards provides excellent thermal shock resistance as evidenced in its typical use as a direct contact board for non-ferrous metals and in fire training burn rooms. They are fire resistant to temperatures approaching 600°C( 1112°F). They also exhibit low thermal conductivities that remain relatively constant over a broad range of operating temperatures. Uses include insulation for Annealing furnaces, Blast furnace stoves, Bustle pipes, Car tops, Forge furnaces, Glass lehrs, Heat treating, Hi-temp mains and flues, Industrial boilers, Kiln cars, Kilns, Laboratory furnaces, Marine boilers, Ovens, Pot furnaces, Petrochem heaters, Pipe supports, Regenerators, Reheat furnaces, Reverberate furnaces, Roasters, Soaking pits Utility boilers, furnaces, ovens, stoves, , soaking pits, regenerators, Our Boards are designed to serve as a backup insulation for any refractory construction, such as insulating fire brick, dense refractory brick, castable, gunning mix, plastic refractory or ceramic fiber. Agni insulation boards are specifically formulated for oven and furnace insulation. This insulation board is available in 3 grades (Agni–400, Agni-500, Agni-600 ) to suit thermal and mechanical strength requirements for various applications. Inside chambers of the ovens are covered with insulating materials having very low thermal conductivity and good structural strength so that heat losses are less and total power consumption of the ovens can be minimized.
AGNI Boards can be selected for oven insulations according to continuous operating temperature requirements.
New concept of using AGNI BOARDS in place of old concept of using GLASS WOOL has got more benefits.
Specific Applications:: Ø High volume baking ovens Ø Steam curing chambers Ø Textile drying ovens Ø Paint booths Ø Curing ovens Ø Powder Coating Ovens
Ø Ladle covers
Boiler baffles
Our materials are used around the world in the most demanding thermal, structural and electrical insulating applications ranging in temperatures from 250°C( 482°F) to 900°C1652°F) SYNDANIO-NA 250 | SYNDANIO 350 | SYNDANIO-NA 350 | SYNDANIO-NA 550 | SYNDANIO-RV | SYNDANIO-RM | AGNI 400 | AGNI 500 | AGNI 600 |
|
